#1

The way of using carbon fiber film

in Powerkiting - Unna 31.10.2013 07:06
von dellshop2 • 20 Beiträge

[Dry paste method steps] use of tools: a clean rag, scraper, credit card
1, clean body paste location, conditions can be used without fiber shedding cloth dipped in 50% ethanol or isopropanol or acetone to scrub, but also soapy water;
2,surface by solvent cleaning solvent to evaporate completely needed to be pasted two rear available, under normal circumstances, the side stick slowly, while tools evenness, while strip the paper away.
3, if the car stickers are less than 10 cm length and width, you can paste the sticker tear. But must be careful not an accident adhesion or sticky ground fall from dust.
4, with a clean rag or scraping [such as phone cards or credit cards] in carbon fiber film repeatedly forced oblique rubbing or scraping a few; until there is no bubble car stickers, not recommended within 24 hours of exposure or car wash. [Wet paste method] car or a large car stickers car stickers for [recommend Double operator] [wet paste method steps] use of tools: watering can, clean rag, scraper, utility knife, duct


zuletzt bearbeitet 31.10.2013 07:07 | nach oben springen


Besucher
0 Mitglieder und 83 Gäste sind Online

Wir begrüßen unser neuestes Mitglied: gjsohcat
Forum Statistiken
Das Forum hat 2188 Themen und 2289 Beiträge.



Xobor Einfach ein eigenes Xobor Forum erstellen