The high performance cutting disc used as the sharpening tool must pay attention to the operation specifications when it is used, otherwise, it will be prone to accidents. So what can be done to use it as a specification?
First, the use of cutting sheets should first comply with the safety rules of GB2494 abrasives;
Second, the cutting piece is only allowed to be used for single piece installation. It is strictly forbidden to install two or more pieces at the same time;
Third, the use speed of the cutting piece cannot exceed the working line speed specified by the trademark of the thin flat cutting disc. When using the pneumatic grinding machine, it is necessary to prevent the air pressure from being unstable, resulting in the cutting piece exceeding the limited speed;
4. The storage time of the resin cutting piece is one year. If the time exceeds the time, the rotary inspection should be carried out again.
5. When using the cutting piece, it is necessary to make a slight force. If the force is too strong, it will easily stop, jam and crush the cutting piece. If it is stuck, the cutting piece should be lifted immediately to avoid the burning of the cutting piece or the chipping.
What are the effects of improper installation of resin cutting blades?
The most important point of using the resin cutting piece is that it is installed and installed, and its working efficiency will be high. However, if the installation is not good, it will have an impact on its use. Let's take a look at the minor effects of the improper installation of resin cutting sheets.
1. Bridge: It is also a film. When the cutting piece is running at high speed, the trajectory cannot be straight, and the direct result is that the material after cutting has a slanting flaw, which may not meet the processing requirements.
2. Shock: This is because when the cutting piece is running at high speed, the vibration is severe when the handle is held, the cutting efficiency is lowered, and waste is caused. The reason is caused by the imbalance of the cutting piece.
3, it will crack, broken: This is due to the inferior quality of the mesh, the amount of binder is too small or expired, the temperature of the furnace is too low, etc., causing cracks in the cutting piece during high-speed operation, and crushing injury in severe cases. people.