How to lay the floor glue
1. Measure the size Firstly, the size of the room should be measured. The measurement should be accurate, and then the interlock detachable elastic double tier sport flooring should be cut according to the structure size. Note: The width of the cut is slightly larger than the required width, which is good for the trimming and trimming when laying.
2, indoor treatment Before paving, we must first deal with the indoor floor; the first is cleaning, to remove the oil stains or dust sand on the ground; the second is flat, the raised position should be shovel flat, the groove can be selected with 107 glue Add cement to make a paste with a weight ratio of 1:2; then level with a spatula, and then flatten it with sandpaper after drying; finally, after the ground is flat, clean and dry, it can be glued and laid.
3, glue application Glue is the last order before laying the elastic double tier sport flooring, the tool should choose the tooth-shaped scraping board. When applying glue, apply glue to the floor according to the size of the floor leather. Spread one piece and lay it together, in this order. Leave a gap of 10 cm at the seam without glue, which is to facilitate the final treatment of the seam.
4, paving the floor The local surface is coated with glue, feel sticky after touching, you can carry out the paving. Pay attention to the alignment of the edges when affixing the floor, and use the long handle brush to catch up and compact at any time. The seams of the floor are generally spliced ​​by overlapping cutting methods, and the width of the overlap is preferably about five centimeters. Use a long steel ruler to align the center of the overlap, cut along the ruler, and then remove the cut edge strips (note: there should be two side strips, don't forget to take the one below), use paint brush to make up Brush the appropriate amount of glue in the seam position, and then use the pressure roller to close the seam and compact it. The residual glue from the seam position should be wiped clean, and the effect of the province is beautiful. Then use a seam fluid to apply a thin layer along the seam.
5, inspection Finally, we have to check whether there are bubbles, whether it is flat. If there are air bubbles, insert the suction air with a syringe and compact it. Finally, use the washing powder to remove the residual rubber marks on the floor leather; if it can not be removed, it can be wiped with alcohol. Floor glue is mainly directly bonded, that is, the floor is glued directly to the ground, requiring the floor to be very dry, smooth and clean. Generally, solid wood floors and cork floors with a length of less than 300 mm are used more. What should I pay attention to when laying the floor? Mainly classified into the following items:
1, the overall trial shop: blending color, living room, aisle and obvious places, you can place the pattern of the same color. And some slightly different, it is recommended to place the bottom of the furniture, or the corner, the overall aesthetics will be improved.
2. When laying the floor, the expansion joint between the elastic flat PP mat volleyball sport flooring and the wall needs to be ≥8mm. No glue can be used between the solid wood floor and the plywood. According to the actual situation, the expansion joint space between the floor and the floor is determined, usually 0, 2-0, 6mm. The northwest, north and northeast regions are suitable for compactness due to the dry climate.
3. When laying the floor and need to nail, you need to use special nails to drive in diagonally. You can't use steam nails to fight....