Everyone knows that after using agricultural equipment, if it is not properly maintained, there will be a series of problems such as rust, as is the case with Garlic Planting Machine. Next, the manufacturer specializing in the production of garlic planting equipment will come to you to summarize how to maintain the equipment.
3 Point hitch Garlic Planting Machin maintenance work:
1. Use high-quality, matched parts and grease, lubricating oil to block the source of harmful impurities.
2. Garlic Planting Machine manufacturers should pay attention to the construction of wet ground. It is necessary to convert the equipment into crawler type or half track type, which can facilitate the timely harvesting of crops. When the mud foot depth is large, increase the width of the unit's ground wheel. Strengthen the anti-slip ability and expand the grounding area as much as possible to avoid the sinking of the garlic planter.
3. The new garlic planter under the windy weather should not drive in the wind direction, avoiding the garlic planter not working properly. The garlic seeder should be adjusted to the small air inlet side, and the air inlet of the leeward side should be adjusted.
4. The protection work of the garlic planter at the work site should be done well to ensure that the corresponding mechanism can work normally to prevent various impurities from entering the machine.
5. The faulty machine should be repaired at a regular repair site. When repairing on site, protective measures should also be taken to prevent the parts replaced at the time of on-site repair from being contaminated by dust and other impurities before entering the machine.
6. When the Garlic Planting Machine is operating on the slope, pay attention to avoiding the cross-slope driving operation. When harvesting long distances uphill, pay attention to increase the rear of the sieve, select a larger sieve hole, and reduce the opening of the air inlet to reduce food loss. There is no need to adjust when harvesting short distances uphill. When harvesting on a downhill long distance, the rear of the sieve should be lowered.